Edgecore switches
This page configures an Edgecore ECS series switch for port-based 802.1X and MAC authentication against Airgate. Airgate has no Edgecore-specific vendor profile; the switch uses the Generic IETF (RFC 3580 / RFC 5176) profile, standard VLAN attributes and, where the switch supports it, RFC 5176 dynamic authorization.
Before you begin
Section titled “Before you begin”- The switch management address, for example
10.0.0.2. - The Airgate RADIUS address (
203.0.113.10in the examples) and a shared secret.
Step 1: Add the switch in Airgate
Section titled “Step 1: Add the switch in Airgate”- Go to Network › Switches and APs › Add device.
- Name
edge-sw1, IP address or subnet10.0.0.2. - Vendor profile: Generic IETF (RFC 3580 / RFC 5176). The dictionary is
IETF, the CoA port3799. - On RADIUS, CoA & RadSec: enter the RADIUS shared secret. Keep Require Message-Authenticator in Access-Requests on if the switch sends it in all requests (802.1X always does; check MAC authentication). Turn on RADIUS CoA / Disconnect (RFC 5176) only if your model supports it.
- Select Save.
Step 2: RADIUS server and accounting
Section titled “Step 2: RADIUS server and accounting”radius-server 1 host 203.0.113.10 auth-port 1812 acct-port 1813 key <shared-secret>aaa accounting dot1x default start-stop group radiusaaa accounting update periodic 10Step 3: 802.1X and MAC authentication
Section titled “Step 3: 802.1X and MAC authentication”dot1x system-auth-control!interface ethernet 1/10 dot1x port-control auto dot1x operation-mode multi-host network-access mode mac-authentication network-access dynamic-vlannetwork-access dynamic-vlanlets the switch apply the VLAN Airgate returns withTunnel-Type,Tunnel-Medium-TypeandTunnel-Private-Group-Id. Build it on Access › Enforcement profiles with the VLAN Enforcement template.Filter-Id(the Filter-Id Enforcement template) applies an ACL by name on models that support it.
Step 4: CoA (where supported)
Section titled “Step 4: CoA (where supported)”Some Edgecore models accept RFC 5176 dynamic authorization. When yours does, allow Airgate (203.0.113.10) as a dynamic-authorization client with the same shared secret on UDP 3799. Airgate’s CoA actions for the generic profile are Disconnect and changing attributes. If the switch has no CoA, leave RADIUS CoA / Disconnect (RFC 5176) off in Airgate; policy changes then apply at the next authentication.
Verify
Section titled “Verify”show dot1xandshow network-accesson the switch show the port authorized.- Monitor › Sign-in log shows the request from
edge-sw1.
Troubleshooting
Section titled “Troubleshooting”| Symptom | Cause | Fix |
|---|---|---|
| No request in the Sign-in log | The switch sends from another address | Register the switch’s real RADIUS source address (see Monitor › Alerts and events). |
| MAC authentication requests missing, 802.1X works | No Message-Authenticator in MAC-authentication requests | Update the firmware, or turn off Require Message-Authenticator in Access-Requests for this device. |
| VLAN not applied | Dynamic VLAN not enabled on the port | Add network-access dynamic-vlan. |
Related
Section titled “Related”© 2026 Airowire Networks Pvt. Ltd. Airgate is a product of Airowire.Product · Release notes · Security